Hi Aleksey - would it be possible to add the cool rolloff control you have in BMS to LFPunch?
-Kyle

I will consider adding a 'high cut' control - not the roll-off control.

OK thanks - I'm sure it will be fine!

You may check out beta version 1.1.1 of LF-Punch - I've added 'cutoff' control.  Please let me know how it works.

Thanks Aleksey!  DLing as we speak... :)

Yes - this is the kind of control I had in mind!

Unfortunately there is something happening when the cutoff gets too close to the low frequency material.  Is it cross-over clash of some type maybe?

For example using the default center freq of 95.8Hz with all other controls set to 0% and 0dB I lower the cutoff freq.  When the cutoff is about 650Hz or so I begin to get a reduction at 200Hz, by the time cutoff gets to 300Hz there is a nice valley at 200Hz about -9dB or so.  I'm watching this is SPAN using pink noise, earlier I was using the cutoff in LF Punch across a full mix and noticed the bass coming apart as I lowered crossover.

That's the best I can explain it, hope that helps!  Thanks for looking into this feature! -Kyle

Thanks for the issue report.  I've fixed it: you may download v1.1.2.

Thanks Aleksey - this version is a lot more flexible and I can make it work better.

OK, good.  I'll rename 'Cutoff' to 'Hi Cut' in the final release, though.