Voxengo Premium Membership - All Voxengo Plugins For a Fixed One-Time Fee
Forums     Plugins     Impulse Modeler and Deconvolver Highs and lows not deconvolved correctly?


As an experiment I have been trying to make some guitar cabinet impulses of a cab sim I use.  I compared the original sim's response with the impulse's response and noticed the highs above like 10khz and the lows below about 80hz are not reporduced quite accurately as seen here: https://dl.dropbox.com/u/75652364/impulse.png.  They appear to be boosted significantly.  Why is this?  Is there a way I can fix this?  The low and high cut features in deconvolver don't seem like they would actually fix the problem, just minimize it a little.  Is there a way to do it properly?

This happens probably because of cab's non-linearity.  You have to run cab at minimal overdrive setting, at moderate volume.  Standard linear deconvolution can't capture non-linearities well.
This topic was last updated 180 days ago, and thus it was archived.  Replying is disabled for this topic.